THE ULTIMATE CHASSIS FOR BEGINNERS AND ENTHUSIASTS ALIKE
- Premium look
- Unprecedented modularity
- Hinged flip panels all around
- Optimized cooling support
- Cable management with ease
- Optimized storage configuration
EXQUISITE STEEL CRAFTSMANSHIP
Mesh intakes spanning the front panel guarantee sufficient airflow in and out of the system, allowing it to run at peak performance.
MORE ADVANCED COOLING SUPPORT
The optimized airflow is a result of the collaboration between the brand-new mesh design, additional exhaust vent holes, and three high-performance ARGB cooling fans.
HIGH-PERFORMANCE BUILT-IN ARGB FANs
3 x 120mm ARGB intake fans pre-installed at the front produce ample airflow while still offering bountiful RGB to liven up your PC build.
ULTIMATE COOLING SUPPORT
Add the BORA DIGITAL ARGB FANs to have more vibrant RGB and increased cooling efficiency for your
LANCOOL II MESH build!
Lighting effects of the 3 included ARGB fans can be fully controlled through the C button and M button located on the top front. Switching between 8 lighting modes has never been this easy.
By plugging the fan hub’s ARGB header into the motherboard’s 3-PIN 5V addressable RGB headers, you’ll be able to synchronize the lighting effects with the motherboard software by switching the M button to the 8th mode.
If your motherboard doesn’t have any 5V addressable RGB headers, make sure to connect the SATA cable connecting the hub to the power supply and use the C and M buttons to control the lighting effects.
The space between the top and bottom chamber now features two removable PSU shroud covers for either 2 x 2.5” SSDs or can be removed to fit 2 x 120mm fans.
The multi-way bracket revolutionizes your notion of fan/radiator installation by offering 4 installation options to best fit your needs.
Do not install a 140/280MM radiator in the inner side of the bracket otherwise irreparable deformation might occur. The correct way to install is to mount fans first then place a radiator on top of the fans.
Model LANCOOL II MESH RGB
Dimensions (D) 478mm x (W) 229mm x (H) 494mm
Motherboard E-ATX(width: under 280mm)/ATX/M-ATX/ITX
Materials 0.8mm SGCC (exterior, MB tray, and most of the interior)
4.0mm tempered glass (both sides)
1.0mm SGCC (interior)
Fan Support Front (multi-way fan/radiator bracket): 3 x 120mm or 2 x 140mm
Top: 2 x 120/140mm
Rear: 1 x 120mm
Above PSU Chamber: 2 x 120mm
Radiator Front (multi-way fan/radiator bracket): 1 x 360/280/240mm
Top: 1 x 240mm (aligned to the left)